Details about Valet Mode On-The-Fly can be found in the main article: Valet Mode On-The-Fly

Vehicle's ignition needs to be on.

When one of the limits have been exceeded in valet mode, the check engine light starts blinking and stays on until valet is turned off.

Enable or Disable Valet Mode

  1. Enter the Custom Code Menu (CCM). Let go once the Check Engine Light (CEL) starts blinking slowly.

    Custom Code Menu details can be found here: Custom Code Menu (CCM)

 

OR

OR

 

  1. Move rocker up and down to navigate through the Custom Code Menu until you reach 7000 RPM (the Valet Mode submenu).

UniRocker uses far up/down on the rocker to navigate the menu. RockerCombo uses short up/down.

  1. Using your button configuration, press “enter” to continue into the Valet Mode submenu.

UniRocker: hold short up/down on the rocker to enter a submenu. RockerCombo: hold BC or RES button.

 

  1. Once entered, the Check Engine Light (CEL) will blink 7 times showing you have entered into the Valet Mode submenu.

 

  1. Select the Valet Mode status you want by using short or far up/down on the rocker to increase/decrease the RPM shown on the tachometer.

UniRocker: far up/down on the rocker to adjust values. RockerCombo: uses short up/down.

 

0 RPM - Disabled

1000 RPM - Enabled

OR

  1. Using your button configuration, press “enter” to accept the Valet Mode status.

UniRocker: hold short up/down on the rocker to accept. RockerCombo: hold BC or RES button.

 

OR

Sub Menu:

Disabled

ECU will operate as normal.

Enabled

Valet Mode will be enabled and the ECU will use parameters set in-app.

Exceed limit has been flagged:

When one of the limiters has been exceeded in valet mode, the check engine light is blinking and stays on until valet is turned off.